Garrett Wade Yankee Push Drill Includes 8 Bits Discount

A superb shop & on-site installation tool

Remember the classic Yankee Push Drill that was once found in every shop and every jobsite tool bag? Made by Stanley for decades until they dropped it about 15 years ago, it was made of chrome-plated solid brass, and beautifully finished. Now we have had it custom-made for Garrett Wade.

This is a beautiful, fast-working, and very special tool, made of the same materials and furnished with original double fluted bits. Every woodworker should have one of these in his or her “quiver” because it is so useful. As you push down, the bit rotates clockwise, cutting the hole, When you stop pushing, the handle springs up and the bit rotates in the other direction – essentially self-clearing.

The bits are stored in the top of the handle and are easy to access. Just slip the size you want (any one of eight – 1/16, 5/64, 3/32, 7/64, 1/8, 9/64, 5/32, 11/64″) into the collet chuck, put the drill tip on the surface and push. Makes a hole up to 1-1/2″ deep. The entire mechanism is protected inside the steel cover. Incidentally, if you have an old Stanley Push Drill, our Spare Set of 8 Bits should fit it.

We also now stock replacement bits, either in a complete set of 8 bits or in a 3 each pack of the four most popular (and fragile) of the smaller bits.
Set of 8 bits include one of each of the following: 1/16″, 5/64″, 3/32″, 7/64″, 1/8″, 9/64″, 5/32″, 11/64″